| Long Description | This design 18 single mode (thru-beam system) photo-electric receiver has a PBT case. It has a supply voltage of 12V to 24V DC. This mono-mode cylindrical photoelectric receiver has a plastic body, is mountable directly on a surface or bracket, thanks to its outer thread and twin nuts. It has VALOX® PBT high strength case ideal for high temperature environments and PMMA scratch-resistant lens for maximum sensor durability. 1 LED display allows to identify status of the sensor. IP65, IP67 and IP69K protection makes this product ready for the harshest environments. It can operate in very cold (-25°C) and hot environments (+55°C). It has a standard M12 connector, compatible with all existing market sensor cabling. It provides double insulation for better people and system protection from electrical shocks. It is CSA and UL certified. | The XCR limit switches range is designed for hoisting and material handling applications. The XCRE58 limit switch is composed of a fixed zinc alloy body and a rotary head. The fixing is done by the body. It has a 6mm metal stay put crossed square rods lever operator with a lateral approach (2 directions). The movement of operating head is rotary. It has twice one normally closed and one normally open slow-break (break before make) contacts with positive opening operation. It has one cable entry tapped for Pg 13.5 cable gland (conforming to NF C 68-300) and it is powered by screw-clamp terminals (clamping capacity 1 x 0.5…2 x 2.5mm²). The contactor can perform an average of 10 million no-load operating cycles without mechanical failure. The XCRE58 limit switch is made of a zinc alloy body. It weighs 1.135kg and measures 95mm in height, 85mm in width, and 75mm in depth. This limit switch complies with CSA and CCC standards, and its protection level complies with IP54 (protected against dust limited ingress and water sprayed). Telemecanique Sensors limit switches are ideal for industrial environments they are precise, robust, reliable, easy to install and offer high repeatability. A limit switch is a device that converts a mechanical motion into an electrical control signal. | This XY2CE Emergency Stop Rope pull Switch is designed with a right hand side anchor point, allowing operator to trigger the stop of potentially dangerous machines at any point of its working area. It operates with a maximum rope length of 70 meters. It has a Zamak body with a booted pushbutton reset, Nitrile bellows, no pilot light, and 2 normally open and 2 normally closed slow break contacts. Its B10D reliability data is 300 000. This emergency stop rope pull switch is suitable for woodworking machines, shears, conveyor systems, printing machines, textile machines, rolling mills, test laboratories, paint shops, surface treatment works, etc. Its IP66 degree of protection makes it ideal for heavy duty use in harsh conditions. It also complies with EN/IEC 60204-1, EN/IEC 60947-5-1, EN/IEC 60947-5-5, EN/ISO 13850, UL NISD, CSA C22.2 No 14-13 standards. When associated and correctly connected to an appropriate safety control unit, it conforms to category 4, performance level PL e, SIL 3 as described in EN/ISO 13849-1, EN/IEC 61508. |
